On

Stop

Throttle trigger

Air cleaner

Purge bulb Push

Fuel return line

Starter handle

Choke lever

RUN (Open)

START (Close)

IMPORTANT

Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety

(90)days when a fuel stabilizer is added. Stored two-stroke fuel may separate. ALWAYS shake fuel container thoroughly before each use.

STARTING COLD ENGINE

Stand the engine upright on a level surface.

Place ignition switch in ON (START/RUN) position.

Push purge bulb 3 to 4 times (or until fuel is visible in fuel return line).

Shift choke lever to close position (START).

Pull starter handle until the engine fires.

Shift choke lever to full open position,and if necessary, start the engine again and allow to warm up before using.

-The clutch engages at approximately 3,500 r/min. Therefore the drill bit may rotate at fast idle engine speed.

STARTING WARM ENGINE

Place ignition switch in ON (START/RUN) position.

Pull starter handle until the engine fires.

-Do not use the choke.

STOPPING ENGINE

Set throttle trigger in idle position.

Place ignition switch in STOP position.

NOTE

When engine does not stop, shift choke lever to close position.

Check and repair ignition switch before starting the engine again.

8

Page 10
Image 10
Echo ED-200 manual Starting Cold Engine, Starting Warm Engine, Stopping Engine