Hexagonal bar

(Part Number 895412-20960)

Box spanner

Spanner (19 mm)

(10 mm)

 

REPLACEMENT OF CHUCK

Replacement of chuck should be done in the following manner:

1.Remove bolt with hexagonal hole fixed in the driving axle.

2.Insert accessory hexagonal bar (Part Number 895412-20960) into chuck and fix.

3.Fit 19 mm spanner onto driving axle and keep it fitted.

4.Fit 10 mm box spanner onto the hexagonal bar and turn it into direction as indicated by an arrow to remove chuck.

5.Fit a new chuck in the reversed order of removing.

ADJUSTING CARBURETOR

(As Required)

GENERAL INFORMATION

The idle speed adjuster screw controls the throttle opening at the idle position.

IDLE ADJUSTMENT

Start engine and allow it to run at high idle until warm.

Idle speed adjustment screw

1.Turn the idle speed screw clockwise until drill bit begins to move.

2.Turn idle screw counterclockwise 1/2 turn or until the drill bit stops (2700 to 3300 r/min).

NOTE

When there is some trouble with the carburetor, contact your dealer.

14