Hedge Clipper 25
Operator's Manual
Storage
WARNING
During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious personal injury may result.
Long Term Storage (over 30 days)
Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:
1. Store unit in a dry, dust free place, out of the reach of children.
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades whenever possible, and always wear gloves to protect hands.
DANGER
Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark, otherwise serious personal injury may result.
2.Place the stop switch in the “OFF” position.
3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.
4.Perform all periodic lubrication and services that are required.
5.Apply clean oil to the entire length of the blade. Be certain the blade bolts are lubricated.
6.Install blade cover on blades.
7.Tighten all the screws and nuts.
8.Drain the fuel tank completely and pull the recoil starter handle several times to remove fuel from the carburetor.
9.Remove the spark plug and pour 7cc (1/4 oz.) of fresh, clean,
A.Place a clean cloth over the spark plug hole.
B.Pull the recoil starter handle
C.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.
10.Install the spark plug (do not connect ignition cable).
IMPORTANT
Always store and transport hedge clippers in a stable, horizontal position. Support gear case and cutting blades to prevent excessive flexing, which may cause damage to these components. Always install blade cover when transporting or storing unit.