| ASSEMBLY |
ASSEMBLY
Power Head Shaft/Lower Shaft Assembly
Parts Required: | PAS Attachment |
1.Set Power Head/Shaft Assembly on a level surface.
2.Pull locator pin (A) out, and turn
3.Remove vinyl cap from attachment drive shaft.
4.Remove cardboard spacer, if necessary.
5.Carefully fit attachment drive shaft assembly into coupler (B) to decal assembly line (C), making sure that the inner lower drive shaft engages the square upper drive shaft socket.
Note: Lower bearing housing and head assembly must be in line with the engine.
6.Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft hole. Insure locator pin is fully engaged by twisting lower drive shaft. Locator pin should snap flush in coupler. Full engagement will prevent further shaft rotation.
7.Secure lower shaft assembly to coupler by tightening clamping knob (D).
Plastic Shield Installation
(Nylon line operation)
Parts Required: | Plastic Debris Shield, Shield Plate, |
| three (3) 5 x 16 mm screws. |
For more information scan this QR code.
B
D
A
C
The plastic shield is for use with the Nylon Line Head only. Install Metal Shield when using plastic or metal blades, or serious injury may result.
1.Remove plastic threaded shaft sleeve and adapter plate (C) from PTO shaft (A).
2.Place the shield on the bottom of the bearing housing flange.
3.Place shield plate (B) on shield, align holes. Install three (3) screws from bottom through plate and shield into gear case.
4.Assemble adapter plate (C) onto PTO shaft.
A
B
C
X7722277602 | 13 |
© 02/2014 ECHO Inc.
