Echo PAS-225SB Nylon Line Head Installation, To Advance Trimmer Line, Remove Nylon Line Head

ASSEMBLY PAS-225SB

Nylon Line Head Installation

Parts Required: Nylon Line Head.

Wear Gloves or personal injury may result:

•Cutoff knife is sharp.

•Gearcase and surrounding area may be hot.

1. Be sure adapter plate (C) remains on PTO shaft (A).

D

A

C

2.Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool (D).

3.Thread line head (E) onto shaft by turning it

counter-clockwise until head is tight against adapter plate	D
(C).

4. Remove locking tool (D).

E

Semi-automatic nylon line heads must be used only with plastic debris shield with cut-off knife. Using nylon line heads with metal debris shield can result in trimmer damage, caused by operation with excessive line length.

Note: Your nylon line head may appear different than nylon line head shown.

To Advance Trimmer Line

See Maintenance Section for nylon line replacement.

Note: To advance trimmer line, tap trimmer head against the ground while the head is turning at normal operating speed.

Remove Nylon Line Head

Note: Do not disassemble nylon line head.

1.Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool (D).

2.Remove line head (E) by turning it clockwise until head is completely off of shaft.

3.Remove locking tool (D).

D

E

14	X7722277602
	© 02/2014 ECHO Inc.