Echo PAS-280 specifications Power Head Shaft/Lower Shaft Assembly, Support Handle Installation

PAS-280 ASSEMBLY

ASSEMBLY

Power Head Shaft/Lower Shaft Assembly

Parts Required: PAS Attachment

1.Set Power Head/Shaft Assembly on a level surface.

2.Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to lock-out position.

3.Remove vinyl cap from attachment drive shaft.

4.Remove cardboard spacer, if necessary.

5.Carefully fit attachment drive shaft assembly into coupler (B) to decal assembly line (C), making sure that the inner lower drive shaft engages the square upper drive shaft socket.

Note: Lower bearing housing and head assembly must be in line with the engine.

6.Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft hole. Insure locator pin is fully engaged by twisting lower drive shaft. Locator pin should snap flush in coupler. Full engagement will prevent further shaft rotation.

7.Secure lower shaft assembly to coupler by tightening clamping knob (D).

Support Handle Installation

Note: Label shows minimum spacing for support handle location.

1.Position support handle for comfortable operation and secure screws.

For more information scan this QR code.

B

D

A

C

MIN

SPACING

X7502312904 13

© 1/2014 ECHO Inc.