Maintenance

MAINTENANCE	PAS-280

5.Remove upper flex cable (F), wipe clean, and apply a thin coating of 1/2 oz. (15ml) of grease.

6.Install cable. Make sure that the flex cable fully engages into the clutch square drive socket.

7.Slide coupler on upper drive shaft until fully seated, and align set screw hole in coupling with hole in upper drive shaft.

8.Install and tighten set screw (D), and tighten clamping screw

(C).

24	X7502312904

Image 24

Contents

Operator’s Manual Burn Hazard Table of Contents Introduction Servicing Information Safety Additional or Replacement ManualsManual Safety Symbols and Important Information International Symbols On / OFF Personal Condition and Safety Equipment Vibration and Cold Repetitive Stress Injuries Equipment Emission Control Exhaust & Evaporative EPA 2010 and Later and/or C.A.R.B. TierProduct Emission Durability Emission Compliance Period Description Description Contents Assembly Power Head Shaft/Lower Shaft AssemblySupport Handle Installation Operation FuelFuel Requirements Handling Fuel After use Starting Cold Engine Purge Bulb Starting Warm Engine Stopping Engine Maintenance Maintenance IntervalsSkill Levels Air Filter Fuel Filter Spark Plug Cooling System Exhaust System Spark Arrestor Screen Carburetor Adjustment Exhaust Port CleaningEngine Break-In High Altitude Operation Lubrication Drive Shaft Upper Maintenance Troubleshooting Engine Problem Troubleshooting Chart Storage Long Term Storage Over 30 Days Specifications Model Specifications Echo Approved Optional Attachments Warranty Statements OWNER’S Responsibility Warranty Statements PAS-280 ECHO, Incorporated

Echo PAS-280 specifications Maintenance