POWER BLOWER | 5 |
OPERATOR'S MANUAL |
EQUIPMENT
Before operation a complete check of the unit must be performed:
-Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.
-Inspect fuel lines, tank and area around carburetor for fuel leaks. DO NOT operate unit if leaks are found.
Spark Arrestor Muffler
-The spark arrestor muffler controls the exhaust noise and prevents hot, glowing particles of carbon from leaving the muffler. Make sure the spark arrestor screen is in good repair and properly seated in the muffler. (Refer to Exhaust System Maintenance pg. 19.)
Parts
-Do not use blower if any part is missing or damaged.
-Have repairs done only by an authorized ECHO Service dealer.
-Do not use any attachment, accessory or replacement part unless it is recommended in this Operator's Manual.
ATTACHMENTS
AND
ACCESSORIES
FUEL
WARNING DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing or handling or serious personal injury may result.
-Use an approved fuel container.
-DO NOT smoke near fuel.
-DO NOT allow flames or sparks near fuel.
-Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.
-NEVER refuel a unit when the engine is HOT!
-NEVER refuel a unit with the engine running.
-DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground.
-Securely tighten fuel cap after refueling.
-Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is repaired.
After Refueling;
-Wipe any spilled fuel from the unit.
-Move at least 3 M (10 ft.) from refueling location before starting.
After use;
-DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container.
3M
10' MINIMUM