Power Edger | 13 | |
Operator's Manual | ||
|
|
|
starting cold engine
warning
The attachment will operate immediately when the engine starts and could result in loss of control and possible serious injury. Keep movable parts of the attachment off the ground and away from objects that could become entangled or thrown.
1.Stop Switch
Move stop switch (A) away from the STOP position.
2.Choke
Move choke (B) to “Cold Start” (
) Position.
3.Purge Bulb
Pump purge bulb (C) until fuel will be visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4.Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Firmly grasp throttle handle with left hand and fully depress throttle trigger to wide open position. Rapidly pull recoil starter handle/rope (D) until engine fires (or maximum five
[5] pulls).
5.Choke
After engine fires or five (5) pulls, move choke lever back to “Run”
(
) position. Hold throttle trigger fully depressed and pull starter handle/rope until engine starts and runs. Release throttle trigger and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2 - 5.
6.After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed.
A
B 
C
D
