Power Edger | 13 | |
Operator's Manual | ||
|
|
|
starting cold engine
warning
The attachment will operate immediately when the engine starts, and could result in possible serious injury. Keep movable parts of the attachment away from objects that could become entangled or thrown, and surfaces that could cause loss of control.
1.Stop Switch
Move stop switch button (A) forward away from the STOP position.
2.Choke
Move choke lever (B) to Cold Start (
) Position.
3.Purge Bulb
Pump purge bulb (C) until fuel is visible in the "Clear" fuel return line. Pump bulb an additional 4 or 5 times.
A
B C
4.Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Firmly grasp right hand grip with left hand and fully depress throttle trigger to wide open position. Rapidly pull recoil starter handle/rope (D) until engine fires (or maximum five
[5] pulls).
5.Choke
After engine fires (or five [5] pulls), move choke lever back to
“Run” (
) position. Hold throttle trigger and throttle trigger lockout fully depressed and pull recoil starter handle/rope until en- gine starts and runs. Release throttle trigger and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls, repeat instructions 2 - 5.
6.After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed.
D
