Shaft Hedge Clipper 11 Operator's Manual
gear housing assembly / drive shaft
NOTE
Hedge Clipper Blades are very sharp. Wear gloves to protect hands.
1.Remove locating bolt (A) and loosen clamping bolt (B).
2.Remove vinyl cap from drive shaft.
3.Slide Gear Housing Assembly onto Drive Shaft. Be certain the Flex Drive Shaft engages the hole in Driver Gear.
IMPORTANT
Flat edge of washer (C) must be against drive shaft.
4.Align locating hole in gear housing with locator hole in drive shaft.
5.Install locating bolt (A). Tighten clamping bolt (B).
A
B
C
Operation
WARNING
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit.
WARNING
Operation of this equipment may create sparks that can start fires around dry vegetation. This unit is equipped with a spark arrestor and a spark arrestor may be required. The operator should contact local fire agencies for laws or regulations relating to fire prevention requirements.
fuel
NOTICE: Use of unmixed, improperly mixed, or fuel older than 90 days, (stale fuel), may cause hard starting, poor performance, or severe engine damage and void the product warranty. Read and follow instructions in the Storage section of this manual.
