Shaft Hedge Clipper 15
Operator's Manual
WARNING
The blades must not move at idle, otherwise serious personal injury may result. Periodic carburetor adjustment may be necessary to as- sure blades do not move at idle.
If blades move, readjust carburetor according to “Carburetor Adjust- ment” instructions in this manual or see your ECHO Dealer.
6.Throttle Trigger
After engine warm up, grip throttle handle with right hand and support handle with left hand. Depress throttle trigger lockout, and gradually depress throttle trigger to increase engine RPM to operat- ing speed.
starting warm engine
The starting procedure is the same as Cold Start except DO NOT close the choke, and do not depress throttle trigger to wide open position.
WARNING
The blades must not move at idle, otherwise serious personal injury may result. Periodic carburetor adjustment may be necessary to as- sure blades do not move at idle.
If blades move, readjust carburetor according to “Carburetor Ad- justment” instructions in this manual or see your ECHO Dealer.
1.Stop Switch
Move stop switch button (A) away from the STOP position.
2.Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3.Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Firmly grasp throttle handle and throttle trigger lockout with left hand. Rapidly pull recoil starter handle/rope (D) until engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
A
C
D 
D
