Echo SRM-210 - page 27

GRASS TRIMMER/BRUSH CUTTER

OPERATOR'S MANUAL 27

LUBRICATION

Level 1.

Tools required: 8 mm Open End Wrench, Screwdriver, Clean rag

Parts Required: ECHO® LUBETM 8 oz. (P/N 91014) or Lithium Base

Grease.

Gear Housing

1. Clean all loose debris from gear box.

2. Remove plug (A) and check level of grease.

3. Add grease if necessary, DO NOT over fill.

Drive Shaft

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull flexible cable from the drive shaft housing, wipe clean and

recoat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the flexible cable back in the drive housing. DO NOT get

dirt on the flex cable.

4. Install the gear housing and shield assembly.

BA

C

Contents

Main Grass Trimmer/Brush Cutter TABLE OF CONTENTS I THE OPERATOR'S MANUAL THE SAFETY MANUAL OPERATOR'S MANUAL 3 M ANUAL SAFETY S YMBOLS S Shaft Decal INTERNATIONAL SYMBOLS OPERATOR'S MANUAL 5 SAFETY INSTRUCTIONS PERSONAL CONDITION AND SAFETY EQUIPMENT Physical Condition Eye Protection Hand Protection EQUIPMENT OPERATOR'S MANUAL 7 E MISSION D CONTENTS Page Page OPERATOR'S MANUAL 11 S PLASTIC SHIELD INSTALLATION NYLON LINE HEAD INSTALLATION A Page PRE - OPERATION OPERATION WITH BLADES Preparing the Trimmer/Brush Cutter for Blade Use Light-Duty Use - Plastic, Nylon, or Metal Blades: Heavy-Duty Use - Plastic, Nylon, or Metal Blades: Page FUEL Fuel Requirements Mixing Instructions Handling Fuel After refueling OPERATOR'S MANUAL 17 O STARTING COLD ENGINE STARTING WARM ENGINE OPERATOR'S MANUAL 19 M MAINTENANCE INTERVALS Page SPARK PLUG COOLING SYSTEMS CLEANING Page Page OPERATOR'S MANUAL 25 CARBURETOR ADJUSTMENT Engine Break-In High Altitude Adjustment Idle Speed Adjustment Page SHARPENING METAL BLADES OPERATOR'S MANUAL 29 T WARNING DANGER S WARNING DANGER Long Term Storage (over 30 days) Page SERVICING INFORMATION PARTS SRM-210 SERVICE ECHO CONSUMER PRODUCT SUPPORT