GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL 15
DE
THROTTLE LINKAGE AND IGNITION LEADS
1. Place throttle linkage cable (C) through adjustment fixture (D) and
install wire end into large carburetor throttle swivel hole (E). Check
throttle for freedom of movement and that wide open throttle / low
idle extremes are adjusted properly. The throttle linkage can be
adjusted by turning the adjustment fixture (D). Consult with your
Echo Dealer for correct adjustment procedure.
2. Connect ignition leads (F) and one ring terminal (G) which attaches
under fan housing screw.
3. Install throttle linkage into bracket clamp (H) and pinch snug with
pliers. Bend bracket up and flush against drive shaft.
C
F
G
H
I
J
BALANCE AND ADJUST UNIT
1. Loosen harness clamp screw.
2. Put on harness and attach unit to harness.
3. Slide harness clamp up (I) or down until unit balances with head
approximately 50-75 mm (2 -3 in.) from the ground.
4. Tighten harness clamp screw.
5. Loosen upper U-Handle clamp screws (J), and position U-Handle
for comfortable operation.
6. Tighten U-Handle clamp screws and 8 mm clamp bolt securely.