Echo SRM-211 A

ASSEMBLY

WARNING DANGER

Use only ECHO approved attachments for these models. Serious injury may result from the use of non-approved

attachment combinations. Read and comply with all safety instructions listed in this manual and attachment manual.

ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been

tested and approved by ECHO for use with these units.

(For Nylon Line Operation)

NOTE

The plastic shield is for use with the Nylon Line Head only.

Install Metal Shield when using plastic or metal blades.

1. Remove plastic sleeve and upper plate (A) from PTO shaft.

2. Install the shield on the bottom of the bearing housing flange.

3. Place shield plate (B) on shield, align holes and install three (3)

5x16 mm screws.

4. Install upper plate (A) onto PTO shaft.

Tools Required: Screwdriver, Head Locking Tool (2), 17x14.5mm

Wrench, Needle Nose Pliers

Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 16mm

screws, Nylon Line Head, Two (2) Pre-cut Nylon Line

8 in. x .095 in., large washer, split pin, hex nut -

L.H. M10 x 1.25