Echo SRM-211, SRM-211U

GRASS TRIMMER/BRUSH CUTTER

OPERATOR'S MANUAL 19

7. Position Lower U-Handle Bracket (K) 400mm (15-3/4 in.) from

engine end of drive shaft. Secure with three (3) 5mm x 30mm

bolts.

8. Install harness hook (included with Blade Conversion Kit) for blade

use. Position 220 mm (8-5/8 in.) from engine end of drive shaft

assembly. DO NOT tighten at this time.

9. Install upper U-Handle and bracket on lower bracket and secure with

one (1) 8mm x 55mm bolt (L) and large circular washer.

10.Secure throttle linkage and leads to drive shaft with cable clips

supplied.

11.Install power head and align gear box, power head and U-handles.

Tighten all screws.

12.Place throttle linkage in slot in bracket with one nut (A) on each side

of bracket. Finger tighten both nuts (A).

13.Attach inner throttle cable to swivel (B). Check throttle for freedom

of movement and that wide open throttle / low idle extremes are

adjusted properly. If adjustment cannot be achieved by adjusting

nuts (A), consult with your Echo Dealer for correct adjustment

procedure.

14.Attach ignition leads (E).

15.Balance unit.

a. Put on harness and attach unit to harness.

b. Slide clamp (M) up or down drive shaft housing until unit

balances with cutting attachment approximately 2 - 3" from

ground.

c. Tighten harness clamp screw.

400 mm (15-3/4 in.)

220 mm

(8-5/8 in.)

ENGINE

END