Echo SRM - 225U manual Handle installation, Throttle linkage and ignition leads

Grass Trimmer/Brush Cutter 13

Operator's Manual

u-handle installation

Tools Required: 17 & 19 mm wrench, Torx T27 L-Wrench,

Parts Required: U-Handle, Clamp w/screws, 8 mm x 55 mm hex bolt, 8 mm flat washer

1.Install upper U-Handle and bracket on lower bracket with one

(1) 8mm x 55mm bolt (A) and (1) large circular washer. Do not tighten bolt securely until final adjustments are completed.

2.Loosen upper (2) U-handle clamp screws (B), and position U- handle as shown.

3.Lightly tighten 8mm bolt (A) and clamp screws (B) to hold U- handle in position until final adjustments are completed.

4.Route throttle linkage and ignition lead assembly along shaft and clip as shown.

A

B

throttle linkage and ignition leads

1.Close choke and remove air filter cover.

2.Place throttle linkage (A) into adjustment fixture (B) and install wire end into large carburetor throttle swivel hole (C). Check throttle for freedom of movement and that wide open throttle / low idle extremes are adjusted properly. The throttle linkage must be adjusted by moving the adjustment nut (D). Consult with your Echo Dealer for correct adjustment procedure.

4.Tighten nut (E).

D A C

E

B

5.Connect 2 ignition stop leads F,G) from throttle cable tubing to 2 ignition leads (F,G) on engine.

F

H

G