WARNING | DANGER | |
SAFETY PRECAUTIONS | 6. SHOULD THE BRUSHCUTTER BE | |
1. ALWAYS USE THE CORRECT BLADE FOR | OPERATED FOR AN EXTENDED PERIOD | |
OF HIGH TEMPERATURES, THE GEAR | ||
THE JOB AS RECOMMENDED. | ||
BOX MAY BECOME VERY HOT. | ||
| ||
2. BE CAREFUL NOT TO HIT ROCKS, | IF TOO HOT TO TOUCH, ALLOW THE UNIT | |
STONES, TREE STUMPS OR ANY | TO COOL DOWN, CHECK THE | |
FOREIGN OBJECT WHICH MAY DAMAGE | LUBRICATION AS PER ‘MAINTENANCE’ | |
THE BLADE. | AND CONTINUE TO OPERATE IF IN | |
3. DO NOT CUT INTO THE GROUND TO | ORDER. | |
7. TO AVOID ENGINE DAMAGE, DO NOT | ||
AVOID DULLING THE BLADE. | ||
4. ALWAYS STOP THE ENGINE AND | RUN ON FULL THROTTLE WITHOUT | |
LOAD. | ||
EXAMINE THE BLADE AFTER STRIKING | ||
8. DO NOT OPERATE THE BRUSHCUTTER | ||
AN OBSTRUCTION. | ||
DO NOT OPERATE WITH A BLADE WHICH | WITHOUT THE HARNESS AND DEBRIS | |
IS BLUNT, BENT, FRACTURED, OR | SHIELD CORRECTLY FITTED. | |
DISCOLORED DUE TO OVERHEAT. | 9. ALWAYS INSPECT THE WORK AREA AND | |
| ||
5. IN THE EVENT, THAT THE BLADE | REMOVE ANY FOREIGN OBJECTS. | |
STRIKES AN OBSTRUCTION, OR IS |
| |
OTHERWISE PREVENTED FROM |
| |
ROTATING IN NORMAL OPERATION, THE |
| |
CENTRIFUGAL CLUTCH WILL SLIP TO |
| |
PREVENT ENGINE DAMAGE. |
| |
IN THIS CASE, STOP THE ENGINE, FREE |
| |
AND EXAMINE THE BLADE AND IF IN |
| |
GOOD ORDER, RESUME OPERATION. |
| |
|
|
PULL
Quick release latch
SHOULDER HARNESS
•Install the harness over the both shoulders and adjust shoulder straps so that the quick release latch rests low on the right hand side.
•Attach the trimmer/brushcutter to the harness by means of the quick release latch.
•Make some practice sweeps as with a scythe and readjust the harness as necessary for comfort and to maintain the cutter parallel to the ground.
WARNING 
DANGER
IN CASE OF EMERGENCY, PULL THE QUICK RELEASE LATCH TO DISCONNECT THE TRIMMER FROM THE HARNESS.
SHIELD
When using a metal blade. Use same as Nylon line.
13