26

7.Remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, 2-stroke engine oil into the cylinder through the spark plug hole.

A.Place a clean cloth over the spark plug hole.

B.Plug the recoil starter handle 2-3 times to distribute the oil inside the engine.

C.Observe the piston location through the spark plug hole. Pull the starter handle slowly until the piston reaches the top of its travel and leave it there.

8.Install the spark plug (do not connect ignition cable).

9.Using garden hose, run clear water through the pump, hoses and strainer.

10. Remove prime port plug and fill the pump housing with 50/50 solution of water and antifreeze.

11. Disconnect suction and discharge hoses.

12. Place a suitable cover over pump.

Removing Pump from Storage

1.Remove spark plug. Cover spark plug hole with clean rag.

2.Pull starter handle several full strokes to remove oil from cylinder.

3.Check spark plug gap; install plug. Connect spark plug cable.

4.Check that guards and shields are fastened in place.

5.Fill fuel tank with fresh fuel mix. (See Fuel sec- tion)

6.Install suction and discharge hoses making sure the connections are air tight.

7.Be sure to reinstall pump drain plug securely and prime the pump before starting.

8.Install prime port plug securely.