Echo 11-Dec, X7505200005, X750011585 manual Install blower pipes t

Power Blower 13 Operator's Manual

PB-500T

WARNING

Never perform maintenance or assembly procedures with engine running or serious personal injury may result.

install blower pipes (t)

1.Place guide loop (G) across clamp, and turn until clip fully engages clamp band.

NOTE

Clamp with cable guide loop (G) fits elbow end of flexible pipe (B).

2.Assemble clamps (A) onto both ends of flexible pipe (B).

3.Assemble flexible pipe (B) to elbow (D) on blower. Position guide loop (G) on inside (blower side) of flexible tube and tighten clamp

(A).

NOTE

A light lubricant may be used to ease assembly of flexible pipe to

blower elbow.

NOTE

Hang handle freely from blower to assure throttle cable is not twisted before installing handle (E).

4.Position cable between the elbow (D) and frame and along the top of the flexible pipe. Loosen knob (H) on handle (E). Align notch in handle with tabs (F). Install onto swivel pipe (C) past long ridges in pipe.

5.Assemble swivel pipe (C) into flexible pipe (B) and tighten clamp

(A).

6.Clip throttle cable into throttle cable guide loop (G).

7.Move handle (E) to desired position. Tighten knob (H) hand tight.

8.Assemble straight pipe (I) onto swivel pipe (C), until you feel light resistance. Do not force connection. Hold swivel pipe and turn straight pipe clockwise, engaging positive locking channels, until connection is firm. Do not force connection.

9.Assemble straight pipe with decal (J) to straight pipe (I) as in step

8.

NOTE

Blower use will eventually loosen pipe connections. Exclusive positive locking system allows pipes to be tightened. If loosening occurs, remove two straight pipes and install according to instruc- tions 8 & 9.

G

G AB A

E

F

D A B A C H

G

E

H

E

I

J

C