ASSEMBLY | |
|
|
ASSEMBLY
Gear Housing Assembly / Drive Shaft
Note: Hedge Trimmer Blades are very sharp. Wear gloves to protect hands.
1.Remove locating bolt (A) and loosen clamping bolt (B).
2.Remove vinyl cap from drive shaft.
3.Slide Gear Housing Assembly onto Drive Shaft. Be certain the Flex Drive Shaft engages the hole in Driver Gear.
Flat edge of washer (C) must be against drive shaft.
A
B
C
4.Align locating hole in gear housing with locator hole in drive shaft.
5.Install locating bolt (A). Tighten clamping bolt (B).
OPERATION
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before removing obstructions, clearing debris, or servicing unit.
Operation of this equipment may create sparks that can start fires. This unit is equipped with a spark arrestor to prevent discharge of hot particles from the engine. Metal cutters can create sparks if the cutter strikes rocks, metal, or other hard objects. Contact local fire authorities for laws or regulations regarding fire prevention requirements.
Fuel
Alternative fuels, such as
Fuel Requirements
Gasoline - Use 89 Octane [R+M/2] (mid grade or higher) gasoline known to be good quality. Gasoline may contain up to 10% Ethanol (grain alcohol) or 15% MTBE (methyl
14 | X7502026704 |
© 10/2014 ECHO Inc.