EDELBROCK AIR CLEANER Catalog #s 1207, 1208, 1209, 1221, 1222, 1235, 1236, 4207, 4210, 4221, 4222, 4223, 4224, 4235, 4236, 4237, 4239, 42203 INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new Air Cleaner Assemblies. If you have any questions or problems, do not hesitate to contact our Technical Hotline at: (800)
DESCRIPTION: Edelbrock Air Cleaner Assemblies - Due to the many different applications of the Edelbrock air filters, some modifications maybe required.
INSTALLATION INSTRUCTIONS:
1.Install suitable air horn gasket and carburetor stud (not supplied) on carburetor(s) and place air cleaner base over carburetor.
2.For single carb models with dual carb tops, thread the special bracket on the carb stud until the two studs protrude through the top of the air cleaner by about 1/2". Bracket must be positioned to clear carburetor choke linkage and choke plate.
3.Install filter and air cleaner lid, checking for clearance between the carb stud and lid. Trim carb stud, if necessary. For carburetors with tall bowl vent tubes, it may be necessary to purchase Edelbrock air cleaner spacer #8092. Vent tube to air cleaner clearance should be no less than 1/8".
Note: To prevent possible hood damage, check for proper hood clearance using clay cones as seen in Figure #1. Don’t shut the hood without checking clearance first!
HOOD CLEARANCE |
CLAY CONES |
Figure #1 |
CRANKCASE VENTILATION:
Note: Some air cleaner kits include the crankcase ventilation adapter, that mounts to the lower side of the air cleaner per the recess seen in Figure #2 (Crankcase ventilation adapter #1205). Other kits may not be applicable.
1.If you wish to use the crankcase ventilation hose fitting, drill two ¼" bolt holes (A) in the recessed area at the rear of the air cleaner base, then drill a few ¼" holes (B) in the larger recess window to allow the fitting to breath (See Figure #2). Bolt the fitting to the base with the ¼" nuts, bolts, and washers. Be sure to
2. Check for clearance between linkage and ventilation hose and rotate base as necessary.
Figure #2
MAINTENANCE:
Some air cleaner assemblies have a
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line:
Edelbrock Air Cleaners | Page 1 of 3 | ©2007 Edelbrock Corporation |
Rev. 10/07 - AJ/mc |
| Brochure |