EdgeStar DEP740EW, DEP400EW Operating the Control Panel, Power, Continuous Mode, Fan Speeds

Operating the Control Panel

Power Use the Power button to turn the portable dehumidifier on and

off. The LED indicator next to “Power” will light up. By default when you first use the power button, the unit will begin to operate in normal fan speed mode.

Note: If the unit was powered off, wait at least 3 minutes before powering it back on.

Auto-Restart:If power to the unit is interrupted, the dehumidifier will restart itself in with the last used mode/settings once the power is restored. The compressor will restart after 3 minutes.

	Auto-Shut Off: The unit will shut off when the set humidity has
	been reached, or when the water bucket is full, has been removed,
	or is not in its proper position.
Continuous Mode	Continuous mode dehumidifies the air until the water bucket is full.
	Use the continuous mode for maximum dehumidification. You will
	not be able to use the set humidity buttons.

To operate the unit in continuous mode:

1)Make sure the power cord is plugged into a power outlet.

2)Press the Power button.

3)Press the Continuous button. The LED indicator next to “Continuous” will light up.

4)Select the fan speed by using the Normal or High button.

Fan Speeds		The dehumidifier has two fan speeds. Use the high fan speed for
		maximum moisture removal. Use the normal fan speed for quieter
		operation.
		Select the fan speed by using the			Normal or	High button.
Setting the Humidity Level		The desired humidity level can be set within a range of 35%
		Relative Humidity (RH) to 80% RH in 5% increments.
		To set the desired humidity level percentage:
		1) Make sure the power cord is plugged into a power outlet.
	Note: Relative Humidity (RH)	2) Press the	Power button. Make sure the continuous light is
	is the ratio of the actual water	turned off.
	content of the air at a given	3) Press the	Increase and		Decrease buttons to set the
	temperature to the potential	desired humidity level. After a few seconds, the LCD display will
	water content at that same
		revert to the actual room humidity level with ±5% accuracy. For
	temperature.
		drier air use the		Decrease button.

5