Edirol PC-50 Mac OS 9 users

30
Getting Connected and Installing Drivers (Macintosh)
If you're using the PC-50 with Mac OS 9, you must set the PC-50 to
OS 9 mode, you must use the following procedure to set the PC-50
to OS 9 mode.
* You must make this setting before you install the driver.
1
Slide the PC-50’s power switch to the OFF position.
2
Switch ON the ADVANCED DRIVER switch (located on the side panel).
3
While holding down the [PGM CHANGE] button,
slide the power switch to the USB position.
4
The display will indicate “PC-50” and then
“OS9.”
The PC-50 is now set to OS 9 mode.
Mac OS 9 users
Setting the PC-50 to OS 9 mode
If the screen indicates:
“Software needed for the
USB device “EDIROL PC-
50” is not available.
Would you like to look
for the software on the
Internet?”➔ click
[Cancel].
■ Canceling the OS 9 mode setting
Before you use the PC-50 with an operating system other than Mac OS 9 (i.e.,
Windows or Mac OS X), you must use the following procedure to cancel the
OS 9 mode setting.
1. Slide the PC-50’s power switch to the OFF position.
2. Switch ON the ADVANCED DRIVER switch (located on the side panel).
3. While holding down the [MIDI CH] button, slide
the power switch to the USB position.
4. The display will indicate “PC-50.” (The “OS9”
indication will not appear.)
The OS 9 mode setting has been cancelled.
PC-50_e.book 30 ページ ２００５年１１月１０日 木曜日 午前１０時３３分