61
System settings
Use
UTILITY mode
(p. 42) to make various system settings for the PC-50.
fig.util*
1
Simultaneously hold the
[MIDI CH]
button and
[PGM CHANGE]
button down.
The display will indicate “UTL,” and the PC-50 enters UTILITY
mode.
fig.sy0
2
Press the
[SYSTEM]
key.
The display will indicate “SY0” and blink.
fig.enter
3
Use the
VALUE encoder
or the
[0]
–
[9]
keys to specify the System setting that
you want to set, and then press the
[ENTER]
button.
* The setting will be cancelled if you press another button instead of the
[ENTER]
button.
Confirm what’s indicated and use the appropriate method to make the setting.
Set the system settings
Display Mode Key-
board Content of the setting Default Setting
method
F8 CLOCK
ON/OFF 0
Specify whether F8 Clock is to be transmitted. OFF p. 62
F8 CLOCK
DEFAULT
TEMPO
1
If “F8 CLOCK ON/OFF” is ON, specify the default value
of the F8 Clock. After the power is turned on, this tempo
will continue to be output until you move a controller to
which TEMPO is assigned.
120 p. 62
VELOCITY
CURVE 2
When you play the keyboard of the PC-50, note messages
will be transmitted with a velocity value that corresponds
to your playing strength. By setting the VELOCITY
CURVE, you can modify the keyboard’s sensitivity and the
curve that is followed when the velocity value changes.
1-MEDIUM p. 63
KEY
VELOCITY 3
Specify whether the transmitted velocity value will vary
according to the keyboard sensitivity and curve you select-
ed in “VELOCITY CURVE”, or will always be transmitted
at a fixed value.
TOUCH p. 64
MIDI I/F
MODE 4
Specify whether the PC-50 will function as a MIDI interface
using its MIDI connectors. ON p. 65
VALUE
ENCODER 5
Select the parameter that is transmitted by the VALUE en-
coder. VOLUME p. 66
FACTORY
RESET 6
Restore all settings of the PC-50 to their factory-set condi-
tion. - p. 68
PC-50_e.book 61 ページ ２００５年１１月１０日 木曜日 午前１０時３３分