Edirol PC-80 - page 23

23
Installation and settings (Windows)
13
Use a USB cable to connect the PC-80 to your computer.
1. With the power switch in the standby position, connect the AC adaptor
to the PC-80.
2. Connect the power cord of the AC adaptor to an AC outlet.
3. Use a USB cable to connect the PC-80 to your computer.
14
Set the PC-80’s power switch to the ON (DC position).
Near the task bar, your computer will indicate “Found New Hardware.”
Please wait.
15
The screen will indicate “Completing the Found New Hardware Wizard.”
Make sure that “EDIROL PC-80 MIDI” or “EDIROL PC-80 WAVE” is
indicated.
Click [Finish] .
The System Settings Change dialog box may appear. Click [Yes] .
Windows will restart automatically.
Then, log on to Windows as the same user as in step 1.
16
The Completing the Found New Hardware Wizard dialog box will appear.
Click [Finish] .
17
If the Driver Setup dialog box appears, click [Close] .
This completes driver installation.
The System Settings Change dialog box may appear. Click [Yes] .
Windows will restart automatically.
Once the connections have
b
een completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
b
efore the unit will operate
normally.
If the “File signature verification” (Step 4) (p. 21) setting was not set to “Ignore,”
a
“Digital Signature Not Found” dialog box will appear.
1. Click [Yes].
2. Continue the installation.
If the “File signature verification” (Step 4) (p. 21) setting was not set to “Ignore,”
a
“Digital Signature Not Found” dialog box will appear.
1. Click [Yes].
2. Continue the installation.
PC-80_e.book 23 ページ ２００５年１１月１０日 木曜日 午前１１時３４分