Ei Electronics Ei164RC, Ei166RC manual This can set fire to the Alarm and damage the house

Models: Ei164RC B16009-R0-160RC Series Ei166RC

1 12
Download 12 pages 45.74 Kb
Page 4
Image 4

B16009-R0-160RC SERIES-U&C 17/1/07 11:13 AM Page 4

will stop when the button is released. Pressing the test button simulates the effect of smoke or heat during a real fire and is the best way to ensure the Alarm is operating correctly.

WARNING: DO NOT TEST WITH FLAME

This can set fire to the Alarm and damage the house

We do not recommend testing with smoke or heat as the results can be misleading unless special apparatus is used.

(iii)Check for any sign of contamination such as cobwebs or dust and clean the alarm as described in the “CLEANING YOUR ALARM” section on page 6, if necessary.

(iv)Interconnected Alarms only - Test the first unit by pressing the button for 10 seconds. All the units should alarm within 10 seconds of the first horn sounding. The red light on the first unit only will flash about once a second. Check all the other units similarly.

(v)Check the functioning of the mains battery back-up directly after installation and then at least yearly as follows:

-Turn off the mains power at the distribution board and check that the green indicator light is extinguished.

-Press the test button and ensure the horn sounds loudly for 10 seconds.

Turn on the mains supply at the distribution board only if the unit passes the above test.

Note: If the mains is disconnected and the battery is almost depleted the unit will beep every 40 seconds for at least 30 days.

(vi)Monitor the alarm over a short period of time for any beeps.

5.1 If the unit is beeping

The Alarm automatically monitors the battery every 40 seconds to ensure that it is satisfactory. If it is depleted it will give a short beep every 40 seconds.

Models Ei141, Ei144 & Ei146 only

Before replacing the battery, check that the beeps are not due to one of the following:

(i)battery snaps not connected properly.

(ii)On the Optical Smoke Alarm only (Ei146) if the unit beeps and the red light does not flash at the same time it indicates a problem with the smoke chamber - see “CLEANING YOUR ALARM” section on page 6.

(iii)If the beeps have continued for over 20 minutes (and the other causes of beeps have been ruled out - see “TROUBLESHOOTING” section on page 11) the battery must be replaced.

See “CHANGING THE BATTERY” section on page 4.

5

Page 4
Image 4
Ei Electronics Ei164RC, Ei166RC manual This can set fire to the Alarm and damage the house, Models Ei141, Ei144 & Ei146 only