Model Ei156TLR Optical
Technical Specification
SensorOptical, uses light scatter from
smoke
Sensitivity: | Complies with BS 5446 Part 1: |
| 2000 |
Source: | Contains no radioactive material |
Airspeed: | Essentially immune to the effect |
| of airspeed. |
Button Test: | Simulates the effect of smoke and |
| checks chamber, electronics and |
| horn. |
Ambient Light: | Chamber housing design and |
| compensation overcomes |
| problems with stray light. |
Automatic | Smoke Chamber is tested every 40 |
| Sec. and unit beeps (without LED |
| flash) if it is degraded. |
Insect Screen: | Prevents insects or debris entering |
| chamber (1.00mm mesh size) |
Supply Voltage: | 230V AC |
Battery back up: | Rechargeable lithium cells |
Continuous green LED |
Alarm: | Electronic Piezoelectric horn |
Alarm Sound Output: | 85dB (minimum) at 3m |
Alarm Status: | Red LED flashes every second on |
| unit sensing fire |
Temperature Range: | 0° to 40°C |
Humidity Range: | 15% to 95% Relative Humidity |
Remote Control: | Ei152, Ei159 or MCP400 |
Interconnect: | Up to 12 interconnected |
| Ei150/151TLR/154TL/155/156TLH/ |
| 156TLR smoke or heat alarms, |
| along with an EI158 relay base |
Fixing: | Screw fixings supplied |
Plastic material: | UL94VO flame retardant |
Dimensions: | 140mm x 120mm x 46mm |
Weight: | 230g |
Warranty: | 5 year (limited) warranty |
Approvals: | Kitemarked to BS EN 14604:2005, |
| CE Approved |
Specifications are subject to change
Installation & Placement
Wiring for Interconnected Alarms
Be very careful about correctly wiring the alarms as mixing Live and Neutral will blow/damage interconnected alarms.
Alarms should be placed in accordance with the general guidelines shown in the diagram above. These recommendations are based on the problem of areas of “dead air” close to corners of rooms and apexes of ceilings, which could result in the prevention of smoke reaching the smoke detector
Please consult instruction booklet for specific installation details
Important Precaution:
Do not install the actual smoke/heat alarm itself in new or renovated buildings until all work is completed (including floor coverings) and the building has been fully cleaned. The wiring can be installed when appropriate. (Excessive dust and debris from building work can contaminate the smoke chamber and cause problems, and it will also invalidate the guarantee). If it must be installed, cover it completely, particularly around the edges, with a dust cover (eg. a plastic bag), until all cleaning is finished.. Connect wires to the unit as in wiring diagram. All wiring must comply with local codes.
Shannon Free Zone, Shannon, Co. Clare, Ireland.
Ph.+353 61 471277 Fx.+353 61 471053
Email. eielectronics@eiltd.ie
Web: www.eielectronics.com
E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior notice. | Ei156TLR DataSht RevB |
