Eiki EIP-S200 For the first time use:, For battery change:, Notes on Lithium Battery (CALIFORNIA USA ONLY)

EN-14
For the first time use:
Remove the transparent insulation tape by pulling it
before use.
For battery change:
1. Push the catch to the right and remove the
battery holder.
2. Remove the old Lithium coin cell and install new
one (CR2025). Ensure that the side with the
mark “+” is up.
3. Push the battery holder back into the remote
control until you feel a click.
Catch
Battery holder
Keep the battery out of the reach of children. There is a danger of death
by accidentally swallowing the battery.
Do not recharge the used battery or expose the battery to fire or water.
Do not dispose of the used battery along with household waste. Dispose
of used batteries according to local regulations.
Danger of explosion may happen if a battery is incorrectly replaced.
Replace only with the same type recommended by the manufacturer.
Notes on Lithium Battery
(CALIFORNIA USA ONLY)
This product uses a Lithium Battery which contains
Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate