EN-33
Symptom
Remote control
doesn’t work.
Cause
The battery could be weak.
The remote control is not being
used within the effective range.
There are some obstructions
between the remote control and
projector.
There are some fluorescent or
other bright lights shining at the
projector’s infrared remote
sensor.
Solution
Replace with a new battery.
Use the remote control within
the effective range.
Check that there are not
obstructions between the
remote control and projector.
Check that there are not any
fluorescent or other bright lights
shining at the projector’s
infrared remote sensor.
Terminal : D-sub 9-pin
SERVICE PORT CONNECTOR
---
RX1A
TX1
---
GND
---
---
---
Serial
1
2
3
4
5
6
7
8
9
COMPUTER INPUT/COMPONENT INPUT TERMINAL (ANALOG)
Terminal : Analog RGB (Mini D-sub 15 pin)
51
2
34
10
9 678
15 14 13 11
12
Red (R/Cr) Input / Output
Ground (Horiz.sync.)
Green (G/Y) Input / Output
-----
Blue (B/Cb) Input / Output
Ground (Red)
Ground (Green)
Ground (Blue)
1
5
2
4
3
6
7
8
5V
Horiz. sync. Input/Output (Composite H/V sync.)
DSUB_PLUG
DDC data
-----
Vert. sync.
DDC clock
9
13
10
12
11
14
15
---
1234
89 7 6
5
Configurations of Terminals