1.Turn off the projector.
2.Allow the projector to cool for at least 45 minutes.
3.Unplug the power cord.
4.Loosen the screws in the lamp cover 1 and remove the cover 2 .
5.Remove the screws from the lamp module 3 , raise the handle 4 , and lift out the module 5 .
6.Insert the new lamp module into the projector and tighten the screws.
7.Replace the lamp cover and tighten the screws.
8.Turn on the projector. If the lamp does not turn on after the
9.Reset the lamp timer. Press MENU, go to Setup > Advanced setup > Reset lamp hours, and press MENU.
Dispose of the used lamp according to local regulations.
Ensure that screws are tightened properly. Screws not tightened fully may result in injury or accidents.
Since the lamp is made of glass, do not drop the unit and do not scratch
the glass.
Do not reuse the old lamp. This could cause the lamp to explode.
Be sure to turn off the projector and unplug the AC power cord before replacing the lamp.
Do not use the projector with the lamp cover removed.
