Eiki LC-SE10 To change the code for the projector, To change the code for the remote control

Setting

Remote control Remote control

This projector provides eight different remote control codes (Code 1- Code 8); the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8). This switching function prevents remote control interference when operating several projectors or video equipment at the same time.

For example operating the projector in “Code 7”, both the projector and the remote control must be switched to “Code 7”.

To change the code for the projector;

Select a remote control code in this Setting Menu.

To change the code for the remote control;

While holding down the MENU button, press the IMAGE button number of times corresponding to the remote control code for the projector. (See page 14 for details.)

USB

This Projector is equipped with USB port for interactive operation between a projector and computer. Set mode following steps below.

Wireless Mouse mode

Select "	" when controlling a computer with Remote Control
of this projector.		Key lock

When pressing the SELECT button at Remote control, the remote control code menu appears.

Projector mode

Select " " when controlling a projector with computer.

NOTE: This is provided not for basic operation but for future use.
Key lock
This function locks operation of the top control and remote control.
It is useful to prevent operation by a third person.
···· not locked.
···· locks operation of the top control. To unlock, use the
remote control.
···· locks operation of the remote control. To unlock, use the
top control.
If the top control accidentally becomes locked and you do not have
the remote control nearby, disconnect the AC power cord to turn off
the power, and then while pressing the SELECT button, connect the
AC power cord again. This will cancel the top control lock.
USB key lock
This function is available when using Projector USB Key optionally	Factory default
supplied. See page 57 for operation.
Lamp counter reset
This function is used to reset the lamp replace counter. When
replacing the projection lamp, reset the lamp replace counter by
using this function. See page 46 for operation.
Factory default
This function returns all setting values except for the lamp counter to
the factory default settings.

Select Key lock and this box appears. Choose one of these with the Point Up/Down button and select [Yes] to activate it.

Select Factory default and this box appears. Select [Yes] , and the next box appears.

Select [Yes] to activate it.

42