Eiki LC-X50 instruction manual Connecting Projector, Terminals Of Projector

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector has input and output terminals on its back for connecting computers and video equipment. Refer to figures on pages 12 to 14 and connect properly.

COMPUTER AUDIO INPUT 2/ AUDIO MONITOR OUTPUT JACK

This terminal is switchable and can be used as computer audio input 2 or audio monitor output (variable).

Set the terminal up as either Computer audio input 2 or Audio Monitor output properly before using this terminal. (Refer to P13, P23.)

COMPUTER INPUT 1 (ANALOG HDB 15-pin)

TERMINAL

Connect computer output to this terminal. (Refer to P13.)

COMPUTER AUDIO

INPUT 1 JACK

Connect an audio output (stereo) from computer to this jack.

(Refer to P13.)

R/C JACK

When using Wired/Wireless Remote Control Unit as Wired Remote Control, Connect Wired Remote Control Unit to this jack with Remote Control Cable (supplied).

COMPUTER INPUT 2/MONITOR OUTPUT						CONTROL PORT CONNECTOR
						When controlling computer
(ANALOG HDB 15-pin) TERMINAL
This terminal is switchable and can		INPUT 1	AUDIO 1		R/C JACK	with Remote Control Unit of
						this projector, connect mouse
be used as computer input or monitor
				RESET		port of your personal computer
output. Set the terminal up as either
		INPUT 2 / OUT		CONTROL PORT		to this connector. (Refer to
Computer input or Monitor output			AUDIO 2
properly before using this terminal.						P13.)
Refer to P13, P23.)		INPUT 3	R – AUDIO 3 – L		USB	USB CONNECTOR (Series B)
Note; This terminal outputs from
COMPUTER INPUT 1 jacks only.		VIDEO/Y – Cb/Pb – Cr/Pr		(MONO)		When controlling computer
		INPUT 4	R – AUDIO 4 – L		S–VIDEO	with Remote Control Unit of
						this projector, connect USB
VIDEO INPUT JACKS		VIDEO/Y – Cb/Pb – Cr/Pr		(MONO)		terminal of your personal
						computer to this terminal.
(INPUT 3 and INPUT 4)						(Refer to P13.)
Connect composite video						S-VIDEO INPUT JACK
output from video equipment		RESET BUTTON
to VIDEO/Y jack or connect
	This projector uses a micro processor					Connect S-VIDEO output
component video outputs to
VIDEO/Y, Cb/Pb and Cr/Pr	to control this unit, and occasionally,					from video equipment to this
jacks. (Refer to P14.)	this micro processor may malfunction					jack. (Refer to P14.)
	and need to be reset. This can be
	done by pressing RESET button with a				AUDIO INPUT JACKS
	pen, which will shut down and restart				(INPUT 3 and INPUT 4)
	unit. Do not use RESET function

excessively.	Connect an audio output
	from video equipment to
	these jacks.
	(Refer to P14.)

EXTERNAL SPEAKER TERMINALS

Connect External Speaker to these terminals.

(Refer to P13 and P14.)

12