Eiki LC-X60 Maintenance, Projector so that Ventilation Slots are not obstructed, Station

APPENDIX

MAINTENANCE

WARNING TEMP. INDICATOR

The Warning Temp. Indicator flashes red to let you know the internal temperature of the projector exceeds the normal level. If the temperature goes up further, the projector will be turned off automatically and the Ready indicator will go out. (The Warning Temp. Indicator continues flashing.) After the cooling-off period, the Ready Indicator lights on again and the projector can be turned on by pressing the On/Off button on the remote control unit or on the top control. When you turn on the projector, the Warning Temp. Indicator will go out.

If the Warning Temp. Indicator is still flashing, check the followings;

1	Ventilation Slots of a projector may be blocked. In such an event, re-position
	a projector so that Ventilation Slots are not obstructed.
2	Air Filter may be clogged with dust particles. Clean Air Filter by following
	section AIR FILTER CARE AND CLEANING on next page.
3	If WARNING TEMP. Indicator remains on after performing above checks,
	Cooling Fans or Internal Circuits may be malfunctioning. Contact the service

station.

TOP CONTROL

Warning Temp. Ready

IndicatorIndicator

When both of the Warning Temp. and Ready indicators are flashing:

When the projector detects an internal problem, it will shut down automatically and both of the Warning temp. and Ready Indicators starts flashing. In this condition, the projector cannot be turned on even if you press the On/Off button on the remote control unit or on the top control. If this case happenes, disconnect and re-connect the AC power cord, and then turn on the projector again to check its operation. If the projector shuts down again or fails to be turned on, the internal check and repair will be required. Plug off the AC power cord and contact service station.

42