Eiki LC-XE10 Auto Set Up Function, Picture Freeze Function, Keystone correction Corner

Basic Operation

Keystone correction (Corner)

1	Press the Point UP/DOWN button to move the red arrow pointer
	to Corner and then press the SELECT button. The mark will
	appear on the screen. Move the projector, align the mark with
	the center of the desired screen and press the SELECT button.
	An arrow will appear on the upper left corner of the screen.
2	Use the POINT UP/DOWN/LEFT/RIGHT button to set the upper
	left positioning and press the SELECT button. Perform the same

procedure for the upper right, lower right and lower left positioning and press the SELECT button. The message “OK?” will appear on the screen. Selecting YES and pressing the SELECT button will correct the alignment as per the 4 points set on the screen.

•The screen will not be corrected when points that exceed the correction limit are selected.

•If you select Corner and press the SELECT button, the keystone adjustment by H-V keystone correction will be canceled.

Please set the projector to take a lead in a screen and push select.

Auto Set Up Function

Auto Set Up function enables you to automatically adjust Focus, Keystone and the computer display parameters (Fine sync, Total dots and Picture position) by just pressing the Auto Set Up button on the top control or on the remote control.

Auto Set Up function operates as follows:

By pressing Auto Set Up button, preparation display is projected on screen. The Auto Set Up sensor on the projector's front panel will scan the projected image and automatically adjust Focus, Keystone and computer display parameters (when computer signal is selected for input) to obtain an optimum screen. The preparation display will disappear after the adjustment is completed.

Auto Set Up operation parameter can be selected in Setting of the main menu. (Refer to Auto set up in Setting on page 39.) If the optimum screen is not obtained, adjust insufficient matters manually.

Note:

•Do not put any obstruction between the Auto Set Up sensor on the projector and the screen, otherwise the Auto Set Up function may not work properly. Do not dirt face of the Auto Set Up sensor on the projector.

•When adjusting Keystone with Auto Set Up button, set screen zoom maximum as Keystone cannot be properly corrected under minimum zoom screen.

Picture Freeze Function

Press the FREEZE button on the remote control to freeze the picture on the screen. To cancel the FREEZE function, press the FREEZE button again or press any other button.

AUTO PC	ON-OFF
▲
D. ZOOM FREEZE	NO SHOW
▲	P-TIMER
IMAGE
▲
PAGE AUTO SET	MUTE
▲

FREEZE button

21