![](/images/backgrounds/140578/140578-4530x1.png)
English
6.TROUBLESHOOTING
If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
zNo picture problems : See No.1 ~ No.2
zImaging problems : See No.3 ~ No.11
zOther problems : See No.12 ~ No.14
|
| Problems | Points to check with Possible Solutions |
|
|
| |
1. | No picture |
| |
| z | Indicator status: Off | Check that the power cord is correctly |
|
|
| connected. If the problem persists, turn off the |
|
|
| monitor power for a few minutes, then turn it |
|
|
| back on and try again. |
| z | Indicator status: Blue | Check the Brightness setting. |
|
|
| Switch the signal Input by pressing the input |
|
|
| signal selection button on the front control panel. |
| z | Indicator status: Yellow | Try pressing a key on the keyboard, or clicking |
|
|
| the mouse. (p. 27) |
|
|
| |
2. | Following messages appear. | These messages appear when the signal is not | |
| (Error messages shown below | inputted correctly, even if the monitor functions | |
| will remain on the screen for 40 | properly. | |
| seconds.) | When the image is displayed correctly after a | |
|
|
| |
|
|
| short time, there is no problem with the monitor. |
|
|
| (Some PCs do not output the signal soon after |
|
|
| powering on.) |
|
|
| Check that the signal cable is properly |
|
|
| connected to the PC or graphics board. |
|
|
| Switch the signal input by pressing the Input |
|
|
| signal selection button on the front control panel. |
| z Whenever an error signal | Use the graphics board’s utility software to | |
|
| message appears, the | change the frequency setting. (Refer to the |
|
| signal frequency will be | manual of the graphics board.) |
|
| displayed in red. |
|
|
| (Example) |
|
|
|
|
|
30 6. TROUBLESHOOTING