Eizo L351 5. ATTACHING AN ARM STAND

The L351 can be used with an arm stand by removing the tilt stand and attaching the arm stand to the terminal.

NOTE

´Use an arm stand that satisfies the followings.

• When using the L351 with an arm stand, the arm stand must be VESA approved :

*Use an arm stand with a 75 mm x 75 mm hole spacing on the arm mounting pad.

*Use an arm stand that is able to support anobject weighing 8.0 kg.

´TÜV/GS approved arm stand.

´Use an arm stand with sufficient stability (mechanical firmness) to support the weight of the monitor.

´Use an arm stand remaining that position where it is manually moved.

´Use an arm stand with the ability to tilt the monitor forward and backward.

´Use an arm stand less than or equal to 500 mm in relation to the desk surface when the arm stand is in its lowest position.

´Please connect cables after attaching an arm stand.

M4 x 16 mm

75 mm

500 mm or less

(Example)

Setup Procedure

1. Lay the L351 down as shown below. Do not scratch the panel.

Soft Cloth or

Cushion

2. Remove the tilt stand by loosening the screws (2 pcs of M4 x 10 mm).

20 5. ATTACHING AN ARM STAND