3
English
TroubleshootingSetting/AdjustmentPrior to use Installation

Connecting Cables

Attention
• When replacing the current monitor with a SX3031W-H monitor, be sure to change the PC settings for
resolution and vertical frequency to those which are available for the SX3031W-H monitor referring to the
resolution table (back of cover page) before connecting the PC.
1 Check that the monitor and the PC are powered off.
2 Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
• When the resolution of the graphics board on your PC is applicable to 2560 × 1600 (Single display);
Connectors on the
PC
DVI connector
Connectors on the
monitor
SIGNAL1
Signal cable DD200DL-BK (supplied)
• When the resolution of the graphics board on your PC is not applicable to 2560 × 1600 (Dual display);
Dual display (simultaneous left and right sides display) is available by using a dual DVI-D system graphics
board or any two graphics boards.
Dual display with 1200 × 1600 resolution is the maximum display size.
DVI connector SIGNAL1
Signal cable DD200DL-BK (supplied)
Connectors on the
PC
Connectors on the
monitor
DVI connector SIGNAL2
Signal cable FD-C39 (supplied)
3 Plug the power cord into a power outlet and the Power connector on the monitor.