ELAR 216 Panel™
©Elation Professional, Los Angeles Ca. 23 www.ElationLighting.com
Clear Last Run
This function resets the lamp “ON” time to zero. Please reset the lamp “ON” time at
every lamp replacement. This procedure tracks the lamp running time so the lamp
can be replaced at the end of it’s recommended duty cycle.
• Select “Clear lamp time” in the system menu.
• The LCD will display “ON” or “OFF.” Were “ON” will reset the lamp time.
• Press enter to confirm.
• Press the Mode/Esc-button to return to the main menu.
Temperature Info.
This function will display the internal head temperature of the fixture in real time. This
setting can be selected to readout temperatures in either Celsius or Fahrenheit.
Software version
This function will display the current operating software version of the fixture.
• The LCD will read “V-X.X”, “X.X” represents the version number, e.g. “V-1.0”,
“V-2.6”.
• Use the UP and DOWN buttons to toggle through the software version of
different IC’s.
9.3 Personality:
Status setting
Address via DMX - This function allows the DMX address to remotely be adjusted
from a DMX console. This setting requires special settings for both the controller and
the fixture. RDMX is on by default. For operational instructions please see Section
10/Page 33 of this manual “Remote DMX addressing.”
No DMX Status – This function dictates how the fixture will function if it looses DMX
signal during normal operation. The default function is set to hold, in which the
fixture will lock into the last DMX signal it received and remain in that position until it
is turned off or begins receiving a new DMX signal. If the fixture is turned on