Electric-Spin 640090 Assembling The Vacuum Cleaner, Floor Brush Use, Removing The Accesories

ASSEMBLING THE VACUUM CLEANER

Always remove the plug from the power socket before fitting or removing accessories.

Adjustment of the telescopic tube:

You can adjust the lenght of the telescopic tube by holding the black ring and pulling or pushing the part with the locking mecanism. It can be unlocked just as easily and brought into a different position.

Fitting the tube:

Insert the tube into the air intake on the top of the appliance. Insert the tube and press until it clicks into position

Removing the tube:

Remove the plug from the power socket. To release the tube, press the button on the end of the tube and pull the tube firmly from the air intake duct.

FLOOR BRUSH USE

-Press the button on the floor brush to the position with brushes for cleaning hard floors.

-Press the button on the floor brush to the position without brushes for cleaning carpets.

REMOVING THE ACCESORIES

-To remove the accessories, pull the accessory firmly off the tube.

INSTRUCTIONS FOR USE

-Before using the appliance unwind a sufficient length of cable and insert the plug into the power socket. A YELLOW mark on the power cable shows the ideal cable length. Do not extend the cable beyond the RED mark. To rewind the power cable, press the rewind button with one hand, and guide the cable with the other hand to ensure that it does not whip causing damage.

-Press the ON/OFF button to switch on the appliance.

USING THE CLEANING

ACCESSORIES

1.The dusting brush

for furniture, venetian blinds, books, lamp shades and shelves.

2.The crevice tool

for radiators, crevices, corners, baseboards and between cushions.

3.The upholstery brush for cushions and drapes.

REPLACING THE DUSTBAG

-After removing the tube, open the front cover by pressing the button and pulling upwards.

-Remove the dustbag.

-Replace the dustbag as described below:

-Insert a new filterbag by leading the cardboard on the filterbag into the drills of the filterholder.

-Close the front cover by pressing it down until it clicks.

REPLACING THE HEPA FILTER

The HEPA filter is the filter placed on the back of the vacuum cleaner:

Press the release-button on the grid and pull it out at the same time.

Remove the HEPA filter and insert a new HEPA filter.Insert the grid back in place.

REPLACING THE MOTORFILTER

The motorfilter is the filter placed behind the dustbag:

Open the front cover and gently pull the filter free of the holders. Insert a new motorfilter.

10