Mounting under a continuous worktop
If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel.
A
Rehingeing the door
The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appli- ance may not be connected to the mains. Remove plug from the mains beforehand.
☞Tilt the appliance slightly towards the rear and prop it securely.
☞ Unscrew the door hinge screws (K)
| and take the door bearing (1) down |
| |
| wards out of its cavity. | 1 | |
☞ | Open the door a little way and take it | ||
|
out downwards.
☞Unscrew the upper pin (A) and screw it into place on the opposite side.
☞Fit the door into the upper pin (A) and close it.
☞Insert the pin of the door bearing (1) into the left hand cavity and screw the bearing firmly into place with the screws (K).
K
A | 12 |
|
9
