Electrolux 16850A What to do if…, Removed, Ance, Drum Redistribute the laundry, Load more laundry

			What to do if…
				31
Problem			Possible cause/Solution
		The transit bolts and packing have not been
		removed.
		•	Check the correct installation of the appli-
			ance.
The machine vibrates or is noisy:		The support feet have not been adjusted
		•	Check the correct levelling of the appliance.
		The laundry is not evenly distributed in the
		drum.
		•	Redistribute the laundry.
		Maybe there is very little laundry in the drum.
		•	Load more laundry.
		The electronic unbalance detection device has
		cut in because the laundry is not evenly dis-
		tributed in the drum. The laundry is redistrib-
		uted by reverse rotation of the drum. This may
Spinning starts late or the machine does		happen several times before the unbalance
		disappears and normal spinning can resume.
not spin:		If, after some minutes, the laundry is still not
		evenly distributed in the drum, the machine
		will not spin.
		•	The laundry load is perhaps to little, add
			more items, redistribute the load manually
			and then select the spinning programme.
		The machine is fitted with a type of motor
		which makes an unusual noise compared with
The machine makes an unusual noise:		other traditional motors. This new motor en-
		sures a softer start and more even distribution
		of the laundry in the drum when spinning, as
		well as increased stability of the machine.
No water is visible in the drum:		Machines based on modern technology oper-
		ate very economically using very little water
		without affecting performance.
		Anti-flooding system has activated.
The display shows the alarm code	:	•	Disconnect the appliance, close the water
			tap and contact the Service Force Centre