15
Heavy build up of frost, possibly
also on the door seal.
Door seal is not air tight (possi-
bly after reversing the door).
Carefully warm the non sealing
sections of the door seal with a
hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand such that it sits
correctly.
The food is too warm.
Interior lighting does not work.
The appliance is near a heat
source.
Temperature is not properly
adjusted.
Please look in the "Initial Start
Up" section.
Light bulb is defective. Please look in the "Changing
the Light Bulb" section.
Turn the temperature regulator
to a colder setting.
Door was open for an extended
period.
Please look in the "Installation
location" section.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Open the door only as long as
necessary.
Symptom Possible Cause Remedy
Unusual noises. The appliance is touching the
wall or other objects.
Appliance is not level.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.
This is normal, no error has
occurred.
The compressor does not start
immediately after changing the
temperature setting.
Water on the floor or on stora-
ge shelves. Water drain hole is blocked.
Move the appliance slightly.
Readjust the feet.
If after all these checks your appliance does not operate correctly, contactyour local AEG Service Force Centre.Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.In-guarantee customers should ensure that the above checks have beenmade as the engineer will make a charge if the fault is not a mechanical orelectrical breakdown.