INSTALLATION INSTRUCTIONS FOR FREESTANDING GAS RANGE
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death.
FOR YOUR SAFETY:
—Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
—WHAT TO DO IF YOU SMELL GAS:
•Do not try to light any appliance.
•Do not touch any electrical switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
—Installation and service must be performed by a qualified installer, service agency or the gas supplier.
Refer to your serial plate for applicable agency certification
Note: For appliances installed in the State of Massachusetts see page 2.
44 5/8"
30" |
Clearances and Dimensions
1.
2.Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level.
Provide Proper Fuel Type
Before Proceeding: Your appliance was preset at the factory to operate on Natural Gas only.
DO NOT attempt to convert this range to LP/ Propane settings without the proper LP/Propane conversion kit provided with the range or obtained from your dealer. Follow all instructions provided with this conversion kit.
Note: For operation at elevations above 2000 ft., appliance rating shall be reduced at the rate of 4 percent for each 1000 ft. above sea level.
p/n 316469104 (0801) | Español - Páginas |
1
