Electrolux 40660 i manual Be cancelled by pressing the appropriate button, Manual setting

Operating Instructions

Adjust the water softener to the setting given in the table that corre- sponds to the hardness of the water in the area where you live.

1	It is only possible to adjust the water hardness setting when a pro-
	gramme is not running. If you have inadvertently started a programme
	(an LED indicator is constantly illuminated), then the programme must
	be cancelled by pressing the appropriate button.
0 1.	The dishwasher must be switched off.

2.Manual setting:

Open the door on the dishwasher.

3. Remove the lower basket from the dishwasher.

4. Turn the water hardness switch to 0 or 1.

5. Re-position the lower basket.

6. Electronic setting:

Press the water-softener and func- tion buttons simultaneously and keep them pressed.

7.In addition press the ON/OFF button.

8.The LED indicator for the water-softener button flashes.

9.Press the water-softener button again.

–The LED indicator for the water-softener button will be illuminated continuously for an initial 5 seconds and then begin to flash.

–The number of flashes corresponds to the hardness setting.

–The sequence of flashes is repeated several times after a 5 second pause.

10.Each time you press the water-softener button the hardness setting will go up by 1.

(Exception: Hardness setting 1 follows hardness setting 5).

–If the hardness setting is changed, the LED indicator for the water- softener button will confirm the change by remaining illuminated continuously for 5 seconds and then flashing again.

–The number of flashes corresponds to the new hardness setting.

–The sequence of flashes is repeated several times after a 5 second pause.

11.Once the hardness setting is correct, press the ON/OFF button. The hardness setting is then saved.

11