Operating Instructions
Setting the water softener
Using the table as a guide, adjust the water softener to that which cor- responds to the hardness of the water in your area:
0The dishwasher must be switched off.
Setting manually:
1. Open the dishwasher door.
2.Remove the lower rack from the
dishwasher.
3.Turn the hardness range switch to 0
or 1 (see table).
4.Replace the lower rack.
Setting electronically:
5.Press the ON/OFF button.
The LED indicators for all the buttons in the control panel that are now able to be selected will become illuminated.
3 | If the only LED indicator illuminated is one that belongs to a pro- |
| gramme button, this means that this dishwashing cycle has been acti- |
vated. The dishwashing cycle must be cancelled (RESET):
Press function buttons 2 and 3 simultaneously for approx.1 second. The LED indicators for all the buttons in the control panel that are now able to be selected will become illuminated.
6.Press function buttons 2 and 3 simultaneously and keep them pressed. The LED indicators for function buttons 1 to 3 will flash.
7.Press function button 1.
The LED indicator for function button 1 will flash. The LED indicator for the end of the dishwashing cycle is flashing and acoustic signals can be heard simultaneously (only when the acoustic signal has been acti- vated):
–The number of times that the LED indicator for the end of the cycle flashes and the number of acoustic signals correspond to the new hardness setting.
–This sequence of flashes and acoustic signals is repeated many times, with a 5 second pause in between.
8.Pressing function button 1 increases the hardness setting by 1. (Exception: hardness setting 1 follows hardness setting 10).
9.When the hardness setting is correct, press the ON/OFF switch. The hardness setting is now saved.
11
