Door and rubber collar
Regularly check whether deposits or foreign bodies are present in the folds of the rubber collar or on the inside of the glass door.
Clean the glass in the door and the rubber collar regularly.
What to do if...
Remedying small faults yourself
If the programme progress display indicates one of the following fault codes during operation:
–END flashes 1x (problem with water inlet),
–END flashes 2x (problem with water outflow),
–END flashes 4x (door open),
please consult the following table.
After the fault has been remedied, press the START/PAUSE button
In the case of other fault messages (one or more flashing indicators on the programme progress display):
switch the appliance off and on again. Set the programme again. Press the START/PAUSE button.
If the fault appears again, please contact your local Service Force Cen- tre.
Problem | Possible cause | Remedy | |
| Power plug not plugged in | Connect the plug to a mains | |
| or problem with the fuse. | socket. Check the fuse. | |
Washing machine does | The door is not shut proper- | Close the door - there should | |
ly. | be an audible click. | ||
not work. | |||
|
| ||
| The START/PAUSE button | Press the START/PAUSE but- | |
| was not pressed for long | ||
| ton for longer. | ||
| enough. | ||
|
| ||
The door cannot be | The child safety device is ac- | Deactivate the child safety | |
closed. | tivated. | device. | |
The END indicator is | The door is not closed prop- | Close the door properly. Re- | |
flashing 4x. | erly. | start the programme. | |
|
|
|
18
