Electrolux 51" Stainless Steel Gas Grill Lighting the Grill, Before Lighting, Match Lighting

Lighting the Grill 12

Back		Knob	Knob	Knob	Knob	Knob	Knob
Infrared		#6	#5	#4	#3	#2	#1
	Left electronic igniter					Right electronic igniter for
	for main burners #2, #3,					bottom infrared burner
#4,		#5, #6 and back				(knob #1) and side burner
	infrared burner

Do not attempt to

“Light” the grill if the

odor of gas is present!!

BEFORE LIGHTING

Important! Before Lighting...

Check the gas supply line for cuts, wear or abrasion.

Always keep your face and body as far away from the grill as possible when lighting.

GRILL BURNER LIGHTING

This unit comes equipped with (2) electronic igniters. The electronic igniter located on the right shelf lights the side burner and bottom infrared burner. The elec- tronic igniter on the left shelf lights the main burners, which are controlled by knobs 2, 3, 4, 5, 6 and the back infrared burner.

LIGHTING THE GRILL WITH ELECTRONIC IGNITERS

Always open the lid before attempting lighting. Push and turn one of the control knobs counter clockwise to the “HIGH” position and immediately press the elec- tronic igniter button. You’ll hear a snapping sound. It may be necessary to hold the electronic starter button for about 4 seconds. If the burner does not light in 4 seconds, turn the knob to OFF and wait 5 minutes before trying again. Repeat above steps to light remaining burners. (See Fig. 15)

MATCH LIGHTING

If by chance the electronic igniter does not light the burner, the burner may be lit with a match. Attach the match to the match extender, located inside the right cart door.

Keep your face as far away from the grill surface as pos- sible and pass the match extender through the spaces in the grill grates to the ports of the back crossover burner between the flavor grids. Position the match near the burner ports, then push and turn the control knob counter clockwise to the “HIGH” position. (See Fig. 16-17)

NOTE: If the grill will not light after several attempts see the trouble-shooting section of this manual. Turn the control knobs to the OFF position when not in use.

Fig. 15

Fig. 16

Crossover Burner

Fig. 17

CONTROL KNOB LAYOUT:

The control knob bezel has stamped markings for the HIGH and LOW settings. Turning the knob so the arrow faces the left H is the HIGH setting. Turning the knob so the arrow faces down

is the LOW setting.

L