Electrolux 56800 manual Next time you dry

Problem	Possible cause	Remedy
		Select a different programme
	Wrong programme selected.	the next time you dry
		(see “Overview of pro-
		grammes” section).
	Lint filter clogged.	Clean lint filter.
	Heat exchanger clogged	Clean heat exchanger.
	with lint.
Drying results unsatis-	Overloading of laundry.	Observe recommended load-
		ing volumes.
factory.
	Ventilation slots in base area	Uncover ventilation slots in
	covered up.	base area.
	Residue on inside surface of	Clean inside surface of drum
	drum or drum ribs.	and drum ribs.
	Conductance of water at in-	Re-programme standard set-
	stallation site differs from	ting for degree of drying (see
	standard setting of ma-	‘Programming options’ sec-
	chine.	tion).
Loading door does not	Fine strainer not in place	Install fine strainer and/or
	and/or large mesh filter not	snap large mesh filter into
close.
	locked in place.	place.
When pressing a but-	Washing protection. After	Turn the programme knob to
ton, the corresponding	the start of the programme,
button flashes several	the option can no longer be	OFF. Set the programme again.
times.	set.
	Programme selector in OFF	Turn programme selector to
Drum light does not	position.	LIGHT or to any programme.
work.	Defective lamp.	Replace lamp (see next sec-
		tion).
Programme inactive,	Condensate tank is full.	Empty condensate tank, then
EMPTY WATER display		start programme with START/
illuminated.		PAUSE button.
Drying cycle ends	Not enough washing load-	Select time programme or
shortly after pro-		higher drying level (e.g. INTEN-
	ed or washing loaded is too
gramme starts. END		SIVE DRY instead of STORAGE
	dry for selected programme.
display illuminated.		DRY).

20