Problem | Possible cause | Remedy | |
| Lint filter clogged. | Clean lint filter. | |
Drying cycle lasts an | Heat exchanger clogged | Clean heat exchanger. | |
unusually long time. | with lint. | ||
| |||
Note: | SPECIAL CARE button | SPECIAL CARE is only suitable | |
After up to 5 hours the | |||
pressed and load volume too | for use with loads of up to | ||
drying cycle finishes | big. | 3kg! | |
automatically | |||
|
| ||
(see ”Drying cycle | Load volume too big. | Reduce load volume. | |
complete”). |
|
| |
Laundry insufficiently spun. | Laundry must be adequately | ||
| |||
| spun. | ||
|
| ||
|
|
|
Changing bulb for interior light
Only use a special bulb which is designed specially for dryers. The spe- cial bulb is available from the local Service Force Centre.
1 Warning! Do not use standard bulbs! These develop too much heat and may damage the machine!
1 Warning! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully remove the fuse.
1.Unscrew the lampcover (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)
2.Replace defective bulb.
3.Replace the lampcover.
1Warning! For reasons associated with safety, the lampcover must be screwed down tightly. If this is not done, the dryer must not be operat- ed.
21
